Ray5 mini and miniS use the same type of ribbon cable, and the replacement method is similar. This guide takes the Ray5 mini as an example.
1. Loosen the Velcro and disconnect the cables for the laser, X/Y-axis motors, and the X-axis limit switch. For the Ray5 miniS, you also need to remove the acrylic base to make the operation easier.
2. Use a 2.5 mm hex wrench to loosen the four screws and remove the front beam cover.
3. Use a 2.5 mm hex wrench to loosen the four screws and remove the mainboard.
4. Disconnect the X and Y axis motor cables (X, Y), the laser cable (PWM), and the X-axis limit switch cable (X-) from the mainboard.
5. Insert the new combined cable into the mainboard according to the cable labels and the markings on the mainboard. Place the mainboard inside the front beam, routing the cable through the gap near the Y-axis limit switch. Make sure the TYPE-C and POWER ports at the front of the beam align correctly with the mainboard connectors.
6. Secure the mainboard with screws using a 2.5 mm hex wrench, and then install the cover plate.
7. Insert the X-axis motor (X), X-axis limit switch (X), Y-axis motor (Y), and laser according to the cable labels, completing the replacement of the combined cable.
Mini:
MiniS:
La scelta di una selezione comporta un aggiornamento dell'intera pagina.
The machine engraves beatififully and text look amazing. However, it look us quite a bit off effort to get started. We still have some doubts, especially about how to engrave múltiple different signs at The same time.
Item was larger than expected but in good order. Arrived on time and package was undamaged. Build is still pending, will comment further when completed
